Betekenis van:
computer error

Voorbeeldzinnen

1. The computer can detect 200 types of error.
2. Computer controlled or "numerically controlled" co-ordinate measuring machines (CMM), having a three dimensional (volumetric) maximum permissible error of indication (MPEE) at any point within the operating range of the machine (i.e., within the length of axes) equal to or less (better) than (1,7 + L/1000) μm (L is the measured length in mm), tested according to ISO 10360-2 (2001);
3. Computer controlled, "numerically controlled" or "stored programme controlled" co-ordinate measuring machines (CMM), having a three dimensional (volumetric) maximum permissible error of indication (MPEE) at any point within the operating range of the machine (i.e., within the length of axes) equal to or less (better) than (1,7 + L/1000) μm (L is the measured length in mm), tested according to ISO 10360-2 (2001);
4. Computer controlled or "numerically controlled" co-ordinate measuring machines (CMM), having a three dimensional (volumetric) maximum permissible error of indication (MPEE) at any point within the operating range of the machine (i.e., within the length of axes) equal to or less (better) than (1,7 + L/1000) µm (L is the measured length in mm), tested according to ISO 10360-2 (2001);
5. In the absence of specific contractual provisions, the acts referred to in points (a) and (b) of Article 4(1) shall not require authorisation by the rightholder where they are necessary for the use of the computer program by the lawful acquirer in accordance with its intended purpose, including for error correction.
6. Ion plating production equipment allowing for the in situ measurement of any of the following: 1. Coating thickness on the substrate and rate control; or 2. Optical characteristics. Note: 2B005 does not control chemical vapour deposition, cathodic arc, sputter deposition, ion plating or ion implantation equipment specially designed for cutting or machining tools. 2B006 Dimensional inspection or measuring systems, equipment, and "electronic assemblies", as follows: a. Computer controlled or "numerically controlled" co-ordinate measuring machines (CMM), having a three dimensional (volumetric) maximum permissible error of indication (MPEE) at any point within the operating range of the machine (i.e., within the length of axes) equal to or less (better) than (1,7 + L/1000) μm (L is the measured length in mm), tested according to ISO 10360-2 (2001); N.B.: SEE ALSO 2B206. b. Linear and angular displacement measuring instruments, as follows: