Betekenis van:
contact arm

Werkwoord

Voorbeeldzinnen

1. When determining points of contact, the length of the arm of the measuring apparatus is not changed during a particular operation.
2. To determine the points of contact, the length of the arm of the measuring apparatus shall not be changed during any given excursion.
3. is the calculated, simulated or measured uplift of the contact wire at a steady arm, generated in normal operating conditions with one or more pantographs with a mean contact force Fm at the maximum line speed.
4. In the case where the headform, with the arm set at minimum length, overlaps the front seat, from the rear ‘H’ point, no contact point is established for this particular operation.
5. In this case, the ECB (or the national central bank(s) acting as the operating arm of the ECB) would directly contact one or a few counterparties in the euro area, selected according to the criteria specified in Section 2.2.
6. When the uplift of the steady arm is physically limited due to the overhead contact line design, it is permissible for the necessary space to be reduced to 1,5 S0 (refer to EN 50119:2001 clause 5.2.1.3).
7. For testing the parts, as referred to in paragraphs 5.3.4.1 and 5.4.2.2 of this Regulation, the arm of the measuring apparatus shall be lengthened until contact is made with the part to be considered, up to a limit of 1000 mm between the pivot point and the top of the head of the apparatus.
8. For electrified lines in Categories II and III, the electrification infrastructure (except for the contact wire and registration arm) shall not enter the gauge envelope defined in the diagram (see Annex F); this is an absolute gauge, and not a reference profile subject to adjustments.