Betekenis van:
evaporate

to evaporate
Werkwoord
  • verdampen, evaporeren, vervluchtigen, vervliegen, verkoken
  • lose or cause to lose liquid by vaporization leaving a more concentrated residue
"evaporate milk"

Synoniemen

Hyperoniemen

Hyponiemen

to evaporate
Werkwoord
    • cause to change into a vapor
    "The chemist evaporated the water"

    Synoniemen

    Hyperoniemen

    Hyponiemen

    to evaporate
    Werkwoord
      • change into a vapor
      "The water evaporated in front of our eyes"

      Synoniemen

      Hyperoniemen

      Hyponiemen

      to evaporate
      Werkwoord
      • wegsmelten, afsmelten, versmelten
      • become less intense and fade away gradually
      "her hopes evaporated after years of waiting for her fiance"

      Synoniemen

      Hyperoniemen


      Voorbeeldzinnen

      1. Water will evaporate after it is boiled.
      2. Evaporate to dryness, occasionally stirring with a glass rod.
      3. Evaporate the solution to approximately 0,5 ml in a stream of nitrogen.
      4. Evaporate the dichloromethane extract down to dryness on the rotary evaporator (4.2) operating under reduced pressure at 40 oC.
      5. Pour a few ml of the solution onto a glass plate and allow the solvent to evaporate.
      6. Evaporate until it had just reached dryness, under reduced pressure at 60 oC by means of the rotary evaporator (4.3).
      7. Remove 200 ml of the filtrate and evaporate to approximately half volume in order to eliminate most of the ethanol.
      8. Evaporate this fraction until it had just reached dryness by means of the rotary evaporator (4.3) at 60 oC.
      9. Electron Beam PVD uses an electron beam to heat and evaporate the material which forms the coating;
      10. If any silica remains in the residue, redissolve it in a few millilitres of hydrofluoric acid (3.4) and evaporate to dryness.
      11. Evaporate the solvent nearly to dryness on the rotary evaporator (4.1) with reduced pressure at a bath temperature not exceeding 40 oC.
      12. Allow to cool, add a few drops of water followed by 10 to 15 ml of hydrofluoric acid (3.4) and evaporate to dryness at about 150 oC.
      13. Add a further 10 ml of hydrochloric acid (3.2). Place the beaker on a sand bath and evaporate until dry to make the silica insoluble.
      14. Dissolve the residue with about 2 ml of hydrochloric acid (3.1), evaporate to dryness and add 5 ml of 6 mol/litre hydrochloric acid (3.2).
      15. Evaporate 100 ml of this extract on the rotary evaporator (see 5.4) nearly to dryness, remove the remaining solvent with a stream of nitrogen (3.10) and redissolve the residue in 10,0 ml of methanol (3.3).