Betekenis van:
gaseous state

gaseous state
Zelfstandig naamwoord
    • the state of matter distinguished from the solid and liquid states by: relatively low density and viscosity; relatively great expansion and contraction with changes in pressure and temperature; the ability to diffuse readily; and the spontaneous tendency to become distributed uniformly throughout any container

    Synoniemen

    Hyperoniemen


    Voorbeeldzinnen

    1. This substance is in gaseous state.
    2. In gaseous state
    3. In gaseous state:
    4. Note 2ML8.d.3 does not control nitrogen trifluoride in its gaseous state.
    5. ‘Vaporizer’ means a device intended to vaporize LPG from a liquid to a gaseous state;
    6. Vapour: the gaseous form of a substance or mixture released from its liquid or solid state.
    7. ML8.d.3 does not apply to nitrogen trifluoride (CAS 7783-54-2) in its gaseous state.
    8. The pressure relief valve shall be mounted inside the container or on the container, in the area where the fuel is in gaseous state.
    9. Note 2ML8.d.3 does not control nitrogen trifluoride in its gaseous state. 4. DNAD (1,3-dinitro-1,3-diazetidine) (CAS 78246-06-7);
    10. “type-approval” means the procedure as defined in Article 2, second indent of Directive 97/68/EC, as amended, whereby a Member State certifies that an engine type or an engine family with regard to the level of emission of gaseous and particulate pollutants by the engine(s) satisfies the relevant technical requirements;
    11. If the requirements set out in Annexes I to VIII and in Articles 3 and 4 are satisfied, in particular where the emissions of gaseous and particulate pollutants and opacity of smoke from the engine comply with the limit values set out in row B1 or row B2 or with the permissive limit values set out in row C of the tables in Section 6.2.1 of Annex I, no Member State may, on grounds relating to the gaseous and particulate pollutants and opacity of smoke emissions from an engine:
    12. Aerosols, this means aerosol dispensers, are any non-refillable receptacles made of metal, glass or plastics and containing a gas compressed, liquefied or dissolved under pressure, with or without a liquid, paste or powder, and fitted with a release device allowing the contents to be ejected as solid or liquid particles in suspension in a gas, as a foam, paste or powder or in a liquid state or in a gaseous state.
    13. Irrespective of concentration levels, one background sampling point shall be installed every 100000 km2 for the indicative measurement, in ambient air, of arsenic, cadmium, nickel, total gaseous mercury, benzo(a)pyrene and the other polycyclic aromatic hydrocarbons referred to in paragraph 8, and of the total deposition of arsenic, cadmium, mercury, nickel, benzo(a)pyrene and the other polycyclic aromatic hydrocarbons referred to in paragraph 8. Each Member State shall set up at least one measuring station.
    14. Note: For steady-state procedure, the filter temperature may be kept at or below the maximum temperature of 325 K (52 °C) instead of respecting the temperature range of 42 to 52 °C. For a partial flow dilution system, the particulate sampling probe must be fitted close to and upstream of the gaseous probe as defined in Section 4.4 and in accordance with Annex VI, section 1.2.1.1, figure 4-12 EP and SP. The partial flow dilution system has to be designed to split the exhaust stream into two fractions, the smaller one being diluted with air and subsequently used for particulate measurement. From that it is essential that the dilution ratio be determined very accurately.