Betekenis van:
ignition switch

ignition switch
Zelfstandig naamwoord
    • switch that operates a solenoid that closes a circuit to operate the starter

    Hyperoniemen


    Voorbeeldzinnen

    1. The ignition switch shall be switched on.
    2. For NOVC vehicles with an operating mode switch, mileage accumulation shall be driven in the mode which is automatically set after turn on of the ignition key (normal mode).
    3. For OVC vehicles with an operating mode switch, mileage accumulation should be driven in the mode which is automatically set after turn on of the ignition key (normal mode).
    4. The automatic cylinder valve shall be operated such that the fuel supply is cut off when the engine is switched off, irrespective of the position of the ignition switch, and shall remain closed while the engine in not running.
    5. The remotely controlled service valve with excess flow valve shall be controlled such that it is automatically closed within five seconds of the vehicle engine stopping, irrespective of the position of the ignition switch.
    6. When the system is not deactivated by the driver, e.g. by turning the ignition (run) switch to ‘off’, or by switching off that particular function if a special switch is provided for that purpose, the warning shall be present as long as the fault condition persists.
    7. a warning, at least audible, additional to the mandatory tell-tale (paragraph 6.11.8.) shall be given if the ignition is switched off or the ignition key is withdrawn and the driver's door is opened, whether the lamps in (paragraph 6.11.7.1.) are on or off, whilst the rear fog lamp switch is in the ‘on’ position.
    8. Not externally chargeable (NOVC HEV) with an operating mode switch vehicles, in hybrid mode, are tested according to Annex I to Chapter 5. If several modes are available, the test shall be carried out in the mode that is automatically set after turn on of the ignition key (normal mode).
    9. The remotely controlled service valve with excess flow valve shall be controlled such that it is automatically closed when the engine is not running, irrespective of the position of the ignition switch, and shall remain closed as long as the engine is not running.
    10. Specified failures or defects which should activate the warning signal mentioned above, but which are not detected under static conditions, shall be stored upon detection and be displayed at start-up and at all times when the ignition (start) switch is in the ‘on’ (run) position, as long as the failure persists.