Betekenis van:
jet engine

Voorbeeldzinnen

1. This project was carried out by Avio, and concerned the low pressure turbine of a Pratt & Whitney engine (PW308) for a large business jet (and small regional jets).
2. A specific category of super alloys are super alloys used in safety-critical rotating parts, for example turbine engine blades and discs for jet aircrafts.
3. The expert described in detail the calculation method adopted for some aspects (for example ‘heavy’ maintenance and components of the A320 family, CFM56-5B jet engine maintenance) to verify the bases (frequency, hourly cost, number of hours, parts, etc).
4. the distance flown in 120 minutes or, if approved by the Authority, up to 180 minutes for turbo-jet aeroplanes, at the one-engine-inoperative cruise speed determined in accordance with subparagraph (b) below;
5. "Technology""required" for the "development" or "production" of gas turbine engine components using "laser", water jet, Electro-Chemical Machining (ECM) or Electrical Discharge Machines (EDM) hole drilling processes to produce holes having any of the following:
6. "technology""required" for the "development" or "production" of gas turbine engine components using "laser" water jet, electro-chemical machining (ECM) or electrical discharge machines (EDM) hole-drilling processes to produce holes having any of the following:
7. "Technology""required" for the "development" or "production" of gas turbine engine components using "laser" water jet, ECM or EDM hole drilling processes to produce holes having any of the following sets of characteristics:
8. a maximum take-off mass less than 45360 kg, the distance flown in 120 minutes or, if approved by the Authority, up to 180 minutes for turbo-jet aeroplanes, at the one-engine-inoperative cruise speed determined in accordance with subparagraph (b);
9. [Jet engine fuel produced by hydrogenation of the middle distillate fraction of the products of hydrocracking of coal extract or solution produced by the liquid solvent extraction or supercritical gas extraction processes and boiling in the range of approximately 180 oC to 225 oC (356 oF to 473 oF).
10. The price construction method is essentially based on sector price comparisons taken from the independent study carried out by Aero Strategy [44]. The expert described in detail the calculation method adopted for some aspects (for example ‘heavy’ maintenance and components of the A320 family, CFM56-5B jet engine maintenance) to verify the bases (frequency, hourly cost, number of hours, parts, etc). It also detailed the following two assumptions made for the purposes of this price construction: