Betekenis van:
plane section

Voorbeeldzinnen

1. Cross-section through the reference plane
2. Cross-section through the reference plane Dimensions in mm
3. Section C Trace of vertical median plane of seat
4. Section A-A of the vehicle in the vertical plane of the centre-line of the inboard seats.
5. The nominal platform height above the running plane shall be either 550 mm or 760 mm, unless otherwise specified in section 7.3.
6. The plane S1 perpendicular to the reference line and situated 65 mm below the tangent S defined in paragraph 7.2.3 defines a section in the head restraint bounded by the outline C. The direction of the straight lines tangential to C representing the intersection of the vertical planes (P and P′), parallel to the plane of symmetry of the seat considered, with the plane S1 shall be traced in the plane S1.
7. The left lateral edge of the plate may not be further to the left than the vertical plane parallel to the plane of symmetry of the tractor and tangent to the point where the cross section of the tractor is at its widest.
8. For all measurements the vehicle must be driven in a straight line over the measuring section (AA′ to BB′) in such a way that the median longitudinal plane of the vehicle is as close as possible to the line CC′.
9. ‘Bumper lead’ for any longitudinal section of a vehicle means the horizontal distance measured in any vehicle vertical longitudinal plane between the upper bumper reference line and the bonnet leading edge reference line;
10. The plane S1, perpendicular to the reference line and situated 65 mm below the tangent S defined in paragraph 6.5.3, determines a section in the head restraint bounded by the outline C.
11. The appropriate proportion of the energy prescribed in Sub-appendix 1 to this appendix shall be applied to the bodywork section by the pendulum such that at the moment of impact the direction of motion of the pendulum makes an angle of 25 degrees (+ 0o, - 5o) to the central longitudinal vertical plane of the bodywork section.
12. drawings in triplicate in sufficient detail to permit identification of the type, showing the position(s) intended for the approval number(s) and the additional symbols in relation to the circle(s) of the approval mark(s), and showing in what geometrical position the lighting units are to be mounted on the vehicle in relation to ground and vehicle longitudinal median plane, and showing each of them in vertical (axial) section and in front elevation, with main details of the optical design including the axis/axes of reference and the point(s) to be taken as centre(s) of reference in the tests and any optical features, of the lens, if applicable;
13. This free space shall permit the free passage of a vertical panel whose form and dimensions are the same as the cylindrical form (paragraph 7.7.5.1.), central section and a thickness of no more than 20 mm. This panel shall be moved, from the cylindrical form tangential position, until its external side is in contact with the dual panel interior side, touching the plane or planes defined by the step upper edges, in the probable direction of motion of a person using the entrance (see Annex 4, Figure 2).
14. the hand brake control when in the released position and the gear lever when in any forward gear position, have, except when placed in the zones defined in paragraphs 2.3.1 and 2.3.2 and in the zones below the horizontal plane passing through the ‘H’ point of the front seats, a surface area of not less than 6 cm2 measured at a cross-section normal to the longitudinal horizontal direction up to a distance of 6,5 mm from the part projecting furthest, the radius of curvature being not less than 3,2 mm. (see Annex X, explanatory notes, paragraph 5.3.2.3)