Betekenis van:
plane figure

Voorbeeldzinnen

1. same plane see Figure 21
2. ± 20o vertically about the transverse axis from the horizontal plane of the vehicle — see Figure 6.
3. the intrusion does not extend beyond the median vertical plane of the seating position (see Annex 4, Figure 18); or
4. This includes the plane inclined at 45° produced 150 mm from the base of the deflector (Figure 6.3.2.2.);
5. ± 25o axial rotation about the longitudinal axis from the horizontal plane of the vehicle — see Figure 7.
6. in the case of sideways facing seats, the forward part of the cylindrical gauge must reach at least the transversal plane which coincides with a vertical plane passing through the centre of the forward seat (Annex 4, Figure 7);
7. ‘Corner of bumper’ means the vehicle's point of contact with a vertical plane which makes an angle of 60° with the vertical longitudinal plane of the vehicle and is tangential to the outer surface of the bumper (see Figure 2);
8. The axis of the impactor must be perpendicular to the horizontal plane with a tolerance of ± 2 ° in the lateral and longitudinal plane. The horizontal, longitudinal and lateral planes are orthogonal to each other (see Figure 8).
9. for side conspicuity markings (see Annex 11, figure 2) the observation plane is parallel to the longitudinal median plane of the vehicles situated 25 m from the extreme outer edge of the vehicle and bounded by:
10. Maximum exposed area (all sides of rectangular wood pieces and wood support frame) not more than 110 % of the total plane area, see Figure b.
11. The clearance zone (Figure 6.1 in Annex II) is defined on the basis of a vertical reference plane and a reference line:
12. The vertical distance from the centre of the front tyres axle to the ground plane (H02) shall be measured (Figure 6.8).
13. Steps shall be at least 150 mm from a vertical plane at the end of the fully compressed buffers (see Annex A figure A5).
14. The reference point is situated in the plane parallel to the longitudinal median plane of the tractor and passing through the centre of the seat, 700 mm vertically above the line of intersection of that plane and the surface of the seat and 270 mm in the direction of the pelvic support from the vertical plane passing through the front edge of the surface of the seat and perpendicular to the longitudinal median plane of the tractor (Figure 1).
15. The cylindrical figure (see Annex 4, Figure 6) used for testing the gangway clearance shall then be moved starting from the gangway, in the probable direction of motion of a person leaving the vehicle, until its centre line has reached the vertical plane which contains the top edge of the uppermost step, or until a plane tangential to the upper cylinder touches the dual panel, whichever occurs first, and retained in that position (see Annex 4, Figure 2).