Betekenis van:
preform

Voorbeeldzinnen

1. Preform/bottle converters
2. the interest of the small and medium-sized preform/ bottle converters had not been duly taken into account.
3. This conclusion was based on the fact that, whereas two cooperating preform/bottle converters supported the introduction of anti-dumping measures, the Association of Plastic Converters opposed it.
4. On this basis, it cannot be concluded that the interests of the preform/bottle converters would constitute a compelling reason against the imposition of anti-dumping measures.
5. It is recalled that the Commission in its provisional findings (recital 196 of the provisional Regulation) could not establish whether it would be in the interest of the preform/bottle converters to impose anti-dumping duties. This conclusion was based on the fact that, whereas two cooperating preform/bottle converters supported the introduction of anti-dumping measures, the Association of Plastic Converters opposed it.
6. They claimed that the price increases resulting from the imposition of measures could not be passed on to soft drink producers but had to be absorbed by preform/bottle converters, which would negatively affect the financial stability for small and medium-sized preform/bottle converters,
7. N.B.: SEE ALSO 1B201. Note: Components and accessories specified in 1B101 include moulds, mandrels, dies, fixtures and tooling for the preform pressing, curing, casting, sintering or bonding of composite structures, laminates and manufactures thereof.
8. Note:Components and accessories specified in 1B101 include moulds, mandrels, dies, fixtures and tooling for the preform pressing, curing, casting, sintering or bonding of composite structures, laminates and manufactures thereof.
9. N.B.:SEE ALSO 1B201. Note:Components and accessories specified in 1B101 include moulds, mandrels, dies, fixtures and tooling for the preform pressing, curing, casting, sintering or bonding of composite structures, laminates and manufactures thereof.
10. Furthermore, as noted in recital 99, it cannot be concluded that the interests of the preform/bottle converters would constitute a compelling reason against the imposition of anti-dumping measures.
11. N.B.:SEE ALSO 1B201. Note:components and accessories specified in 1B101 include moulds, mandrels, dies, fixtures and tooling for the preform pressing, curing, casting, sintering or bonding of composite structures, laminates and manufactures thereof.
12. Note: Components and accessories specified in 1B101 include moulds, mandrels, dies, fixtures and tooling for the preform pressing, curing, casting, sintering or bonding of composite structures, laminates and manufactures thereof.
13. Hence, the risk for any outsourcing of preform/bottling capacity would be limited to the case of preforms for soft drinks producers, which account for only about 40 % of the total consumption of the product concerned.
14. It is recalled that the Commission in its provisional findings (recital 196 of the provisional Regulation) could not establish whether it would be in the interest of the preform/bottle converters to impose anti-dumping duties.
15. As concerns the risk of outsourcing, it is recalled that health regulations in respect of the bottling of mineral water require that preform bottles should be in principle produced at the place at which they are filled.