Betekenis van:
radius of curvature

radius of curvature
Zelfstandig naamwoord
    • the radius of the circle of curvature; the absolute value of the reciprocal of the curvature of a curve at a given point

    Hyperoniemen


    Voorbeeldzinnen

    1. minimum radius of curvature
    2. Radius of curvature
    3. Minimum radius of curvature
    4. minimum radius of curvature (4.2.6),
    5. radius of curvature of stabling tracks quoted in 4.2.25.3.
    6. The radius of curvature shall not be less than 3,2 mm.
    7. Point 4 at the place where the radius of curvature is smallest on the longest median,
    8. The corners of the rectangle may be rounded to a radius of curvature not exceeding 250 mm.
    9. The buffer heads shall be convex and the radius of curvature of their spherical working surface equal to 2750 mm ± 50 mm.
    10. The buffer heads shall be convex with a radius of curvature of their spherical working surface of 2750 mm ± 50 mm.
    11. A sharp edge is an edge of a rigid material having a radius of curvature of less than 2,5 mm except in the case of projections of less than 3,2 mm, measured from the panel. In this case, the minimum radius of curvature shall not apply provided the height of the projection is not more than half its width and its edges are blunted.
    12. The end of the clutch and brake levers shall be perceptibly spherical and have a radius of curvature of at least 7 mm. The outer edges of these levers shall have a radius of curvature of not less than 2 mm. The verification is done with the levers in non-applied position.’
    13. The lower edge of the instrument panel shall, unless it meets the requirements of paragraph 5.1.2 above, be rounded to a radius of curvature of not less than 19 mm. (see Annex X, explanatory notes, paragraph 5.1.3)
    14. A ‘sharp edge’ is an edge of a rigid material having a radius of curvature of less than 2,5 mm except in the case of projections of less than 3,2 mm, measured from the panel according to the procedure described in paragraph 1 of Annex VI. In this case, the minimum radius of curvature shall not apply provided the height of the projection is not more than half its width and its edges are blunted (see Annex X, explanatory notes, paragraph 2.18).
    15. A sharp edge is an edge of a rigid material having a radius of curvature of less than 2,5 mm except in the case of projections of less than 3,2 mm, measured from the panel.