Betekenis van:
tangent plane

tangent plane
Zelfstandig naamwoord
    • the plane that contains all the lines tangent to a specific point on a surface

    Hyperoniemen


    Voorbeeldzinnen

    1. The 25,4 mm dimension means the measurement from a horizontal plane passing through the ‘H’ point to the horizontal tangent to the lower profile of the headform.
    2. The origin of the angles of geometric visibility is the perimeter of the projection of the illuminating surface on a transverse plane tangent to the foremost part of the lens of the headlamp.
    3. The plane S1, perpendicular to the reference line and situated 65 mm below the tangent S defined in paragraph 6.5.3, determines a section in the head restraint bounded by the outline C.
    4. The point of impact is defined by the plane tangent to the engine bonnet and the protective structure passing through the top outer points of the front tyre (Figure 6.7).
    5. The point of impact is defined by the plane tangent to the protective structure passing through the line made by the top outer points of the front and rear tyres (Figure 6.7).
    6. The plane S1 perpendicular to the reference line and situated 65 mm below the tangent S defined in paragraph 7.2.3 defines a section in the head restraint bounded by the outline C. The direction of the straight lines tangential to C representing the intersection of the vertical planes (P and P′), parallel to the plane of symmetry of the seat considered, with the plane S1 shall be traced in the plane S1.
    7. The left lateral edge of the plate may not be further to the left than the vertical plane parallel to the plane of symmetry of the tractor and tangent to the point where the cross section of the tractor is at its widest.
    8. The height of the uncompressed seat cushion relative to the floor shall be such that the distance from the floor to a horizontal plane tangent to the front upper surface of the seat cushion is between 400 mm and 500 mm.
    9. Either the total area of the projection of the distinct parts on a plane tangent to the exterior surface of the transparent material and perpendicular to the reference axis shall occupy not less than 60 per cent of the smallest quadrilateral circumscribing the said projection, or the distance between two adjacent/tangential distinct parts shall not exceed 15 mm when measured perpendicularly to the reference axis.