Betekenis van:
travel along

Werkwoord

Voorbeeldzinnen

1. We're going to travel along the river until the sea.
2. Also, I used to wonder what would happen if I were to travel along the earth or on a road in a straight line for a very great distance. Would I eventually end up against a card-board wall which constituted a small part of the great card-board box which enclosed the universe? And if so, what was beyond it? Perhaps there were more card-board boxes, all stacked up inside an even greater card-board box. When you make a theory that depends on another theory which in turn depends on another, this is the sort of conclusion you may form. It is one of the major pitfalls of linear thinking which can wreak havok with your interpretation of social situations.
3. During the test, it must be possible to travel along a straight section of the road without unusual steering correction by the driver.
4. the tractor must travel along the section at the same test speed at least three times for at least 10 seconds;
5. It must be possible to travel along a straight section of road without unusual steering correction by the driver and without unusual vibration in the steering system at the maximum design speed of the vehicle.
6. Rolling stock coordinates: rolling stock coordinates, figure 1, are based on the right hand rule Cartesian coordinate system, where the positive X-axis (longitudinal) is along the vehicle in the direction of travel, the Z-axis is vertically upwards and the origin is at the centre of the wheelset axle.
7. No part of the trailer must move more than 0,5 m beyond the tangent to a circle with a radius of 25 m when towed by a vehicle leaving the circular path along the tangent while maintaining the speed of 25 km/h. This requirement must be met from the point the tangent meets the circle to a point 40 m along the tangent. After that point the trailer must travel without excessive deviation or unusual vibration in its steering equipment (see Figure 3 below).
8. Spindle"run-out" and "camming" less (better) than 0,0004 mm TIR; and b. Angular deviation of slide movement (yaw, pitch and roll) less (better) than 2 seconds of arc, TIR over 300 mm of travel. c. Machine tools for grinding, having any of the following characteristics: 1. Having all of the following: a. Positioning accuracy with "all compensations available" equal to or less (better) than 4 μm according to ISO 230/2 (1988) [1] Manufacturers calculating positioning accuracy in accordance with ISO 230/2 (1997) should consult the competent authorities of the Member State in which they are established. or national equivalents along any linear axis; and