Betekenis van:
vertical surface

Voorbeeldzinnen

1. Ferrets tend to defecate against a vertical surface in one area of the enclosure.
2. the impacting surface shall be vertical and perpendicular to the median longitudinal plane of the vehicle struck;
3. To determine the lower, upper and lateral limits of the illuminating surface, only vertical and horizontal planes shall be used.
4. However, the vertical distance between the gangway surface and the floor of the seating area shall not exceed 350 mm.
5. ‘Corner of bumper’ means the vehicle's point of contact with a vertical plane which makes an angle of 60° with the vertical longitudinal plane of the vehicle and is tangential to the outer surface of the bumper (see Figure 2);
6. The service door entry height shall be measured as the vertical distance measured on a vertical plane of the horizontal projections of the mid point of the door aperture and the top surface of the lowest step.
7. This test specifies a method of test for measuring the lateral spread of flame along the surface of a specimen of product orientated in vertical position.
8. Gillnets are strings of single, double or triple netting walls, vertical, near the surface, in midwater or on the bottom, in which fish will gill, entangle or enmesh.
9. On the rear surface, the direction of impact from the rear towards the front in a longitudinal plane shall be at an angle of 45° to the vertical.
10. To determine the lower, upper and lateral limits of the illuminating surface, only screens with horizontal or vertical edges shall be used.
11. The vertical plane through the wheel axis intersects its median plane along a straight line which meets the supporting surface at one point.
12. the area forward of a transverse vertical plane passing through the centre of the seating surface of the driver's seat (in its rearmost position);
13. The size of the head from chin to crown shall be between 70 % and 80 % of the vertical dimension of the surface of the photograph.
14. two vertical planes 200 mm on either side of the reference plane, these vertical planes extending 300 mm upwards from the plane defined in 1.6.2.8 below and longitudinally from the surface defined in 1.6.2.11 below to the vertical plane perpendicular to the reference plane passing (210 – ah) mm in front of the seat index point;
15. It should include consideration of the body size of the animal, a surface sufficiently cushioned to prevent injury, adequate stall drainage, correctly positioned stall dividers and head rails, lateral and vertical freedom for head movement and adequate lunging space.