Betekenis van:
volt

Voorbeeldzinnen

1. volt
2. Volt-hours
3. Corresponding voltage values for digital only interface monitors that correspond to the brightness of the image (0 to 0,7 volt) are:0 volt (black) = a setting of 00,1 volt (darkest shade of gray analogue) = 36 digital gray0,7 volt (full white analogue) = 255 digital grayPlease note that future digital interface specifications may widen this range, but in all cases, 0 volt shall correspond to black and the maximum value shall correspond to white, with 0,1 volt corresponding to one-seventh of the maximum value.
4. For all fixed pixel displays (e.g. LCDs and others), test pattern (VESA FPDM Standard 2.0, A112-2F, SET01K) shall be displayed that provides eight shades of gray from full black (0 volt) to full white (0,7 volt).
5. Then, test pattern (VESA FPDM Standard 2.0, A112-2F, SET01K) shall be displayed that provides eight shades of gray from full black (0 volt) to full white (0,7 volt) [3].
6. Apparent power is defined as (volts) × (amps), and is usually expressed in terms of VA or volt-amps.
7. For monitoring systems affected by low vehicle battery or system voltages, manufacturers may request approval to disable monitoring systems when the battery or system voltage is below 90 per cent of the nominal voltage (or 11.0 Volts for a 12 Volt battery, 22.0 Volts for a 24 volt battery).
8. The golf cart has a maximum speed of 6,5 km/h and is equipped with a 24 volt battery-operated motor.
9. The technician shall then display a test pattern (VESA FPDM Standard 2.0, A112-2H, L80) that provides a full white (0,7 volt) box that occupies 80 % of the image.
10. For CRT monitors, the technician shall initiate the AT01P (Alignment Target 01 Positive Mode) pattern (VESA FPDM Standard 2.0, A112-2F, AT01P) for screen size and use it to set the computer monitor to the manufacturer’s recommended image size, which is typically slightly smaller than maximum viewable screen size. Then, test pattern (VESA FPDM Standard 2.0, A112-2F, SET01K) shall be displayed that provides eight shades of gray from full black (0 volt) to full white (0,7 volt) [3].
11. Special names for the unit of power: the name volt–ampere (symbol “VA”) when it is used to express the apparent power of alternating electric current, and var (symbol “var”) when it is used to express reactive electric power.
12. Use portable measuring devices such as manometer sets, thermometers and multi-meters for measuring Volt/Amp/Ohm in the context of indirect methods for leakage checking, and interpret the measured parameters.
13. ring-shaped motor stators for multiphase AC hysteresis (or reluctance) motors for synchronous operation within a vacuum in the frequency range of 600 to 2000 Hz and a power range of 50 to 1000 Volt-Amps;
14. Ring-shaped motor stators for multiphase AC hysteresis (or reluctance) motors for synchronous operation within a vacuum in the frequency range of 600 to 2000 Hz and a power range of 50 to 1000 Volt-Amps;
15. The technician shall next display a test pattern (VESA FPDM Standard 2.0, A112-2H, L80) that provides a full white (0,7 volt) box that occupies 80 % of the image.