Betekenis van:
y-axis

Voorbeeldzinnen

1. Pushing that button will make the object pivot around the y axis.
2. The Y-axis is the lateral axis.
3. the line parallel to the y-axis at v = 0,
4. Plot the values of absorbance on the y axis against apo-carotenic ester concentration on the x axis.
5. the line parallel to the y-axis at v = 5 km/h,
6. Measure the absorbances at 440 nm against a petroleum spirit (4.2) blank. Plot the values of absorbance on the y axis against apo-carotenic ester concentration on the x axis.
7. Jig grinders with axes limited to x, y, c and a where c axis is used to maintain the grinding wheel normal to the work surface, and the a axis is configured to grind barrel cams;
8. Storage on the north-south axis of Spain (new sites) in Cantabria, Aragon, Castilla y León, Castilla — La Mancha and Andalucia
9. ‘Centre plane of occupant’ (C/LO) means the median plane of the 3-D H machine positioned in each designated seating position; it is represented by the co-ordinate of the ‘H’ point on the ‘Y’ axis.
10. ‘Centreplane of occupant’ (C/LO) means the median plane of the 3-D H machine positioned in each designated seating position; it is represented by the coordinate of the ‘H’ point on the ‘Y’ axis.
11. ‘Centreplane of occupant’ (C/LO) means the median plane of the 3-D H machine positioned in each designated seating position; it is represented by the coordinate of the ‘H’ point on the ‘Y’ axis.
12. The maximum projection shall be determined in accordance with Annex VI, paragraph 1, i.e. by using a 165 mm diameter sphere and determining the maximum variation in height of the ‘y’ axis.
13. ‘Centreplane of occupant’ (C/LO) means the median plane of the 3-D H machine positioned in each designated seating position; it is represented by the co-ordinate of the ‘H’ point on the ‘Y’ axis.
14. ‘Centreplane of occupant’ (C/LO) means the median plane of the 3-D H machine positioned in each designated seating position; it is represented by the co-ordinate of the ‘H’ point on the ‘Y’ axis. For individual seats, the centreplane of the seat coincides with the centreplane of the occupant.
15. If a pull handle or knob has a width dimension equal to or more than 50 mm and is located in a zone such that if it were less than 50 mm in width the maximum projection would be determined using the headform measuring apparatus of Annex VI, paragraph 2. The maximum projection shall be determined in accordance with Annex VI, paragraph 1, i.e. by using a 165 mm diameter sphere and determining the maximum variation in height of the ‘y’ axis.